Crosstown Traffic: Collin Cunningham at Adafruit demonstrates PC Board milling

Collin Cunningham at Adafruit put up another Collin’s Lab video yesterday on the Adafruit Blog, this time demonstrating an alternate method of making printed circuit boards using a small CNC mill instead of etching.  If you don’t want to go to that site I embedded the video below.

No, the mill ain’t cheap.  Adafruit sells it for just under $2200.  But it would look great next to a 3D Printer… and as much as I want a PolyPrinter ($2400), I can’t justify that either.

Collin used to publish these videos and other posts over on the Make: magazine website but defected to Adafruit a few years ago.

 

Published from DFW, Texas

 

Leave a Reply

Your email address will not be published.

*